Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende Überarbeitung | ||
| en:eingabe_der_scher-_und_mischteile:kreuzlochmischteil [2024/10/17 16:33] – [Cross-hole mixing section] neelest | en:eingabe_der_scher-_und_mischteile:kreuzlochmischteil [2025/05/06 14:20] (aktuell) – cschall | ||
|---|---|---|---|
| Zeile 3: | Zeile 3: | ||
| ===== Cross-hole mixing section ===== | ===== Cross-hole mixing section ===== | ||
| - | {{ : | + | {{ : |
| {{ : | {{ : | ||
| In the cross-hole mixing section, the distances between the mixing rings are referred to as gaps. The channel depths also refer to these gaps. The difference between the number of rings and the number of gaps must not exceed 1. The width of the gaps is calculated from the other sizes and can therefore not be edited. | In the cross-hole mixing section, the distances between the mixing rings are referred to as gaps. The channel depths also refer to these gaps. The difference between the number of rings and the number of gaps must not exceed 1. The width of the gaps is calculated from the other sizes and can therefore not be edited. | ||
| - | {{ : | + | {{ : |
| ===Further topics=== | ===Further topics=== | ||
| Zeile 21: | Zeile 21: | ||
| * [[en: | * [[en: | ||
| * [[en: | * [[en: | ||
| - | * [[en: | ||
| ==Input of shearing and mixing parts== | ==Input of shearing and mixing parts== | ||