Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:eingabe_der_schneckendaten:eingabe_der_schneckendaten [2024/10/25 15:50] – neelest
+++ en:eingabe_der_schneckendaten:eingabe_der_schneckendaten [2026/08/21 08:35] (aktuell) – admin
@@ Zeile 1: / Zeile 1: @@
 ======Define screw data======
+The following window opens when you create a screw:
 {{ :eingabe_der_schneckendaten:rex171_eingabe_schneckendaten_en_001.png?nolink |}}
+The extruder diameter (nominal diameter / diameter of the barrel) can be entered or changed in the upper area.
+The greyed out fields are only used to display the ACTUAL screw geometry.
+Below the graphic representation of the screw, there are two buttons for further optional configuration:
+  * Input of the mechanical properties (see also [[en:berechnungen:festigkeitsberechnung|Strength calculation]])
+  * Input of an [[en:eingabe_der_schneckendaten:eingabe_innentemperierter_schnecken|internal temperature control]]
+The screw can be defined in the centre of the window. The screw always starts automatically (and must) with a feed zone. All possible zones are listed in the left-hand area. These can be added to the current screw configuration by double-clicking or by selecting and pressing the arrows (Insert section{{:eingabe_der_schneckendaten:pfeil_rechts.png?nolink|}}). The order of the screw zones can be adjusted using the arrows on the right (move section forwards {{:eingabe_der_schneckendaten:pfeil_hoch.png?nolink|}} / backwards {{:eingabe_der_schneckendaten:pfeil_runter.png?nolink|}}). The required zone data can be entered by double-clicking on the list entry in the current screw configuration or by pressing the //Edit// button.
+If REX has automatically made adjustments to zones (e.g. if the channel depth of a compression section is changed, the channel depths of the adjacent sections are automatically adjusted), the overview of all automated changes can be viewed using the //Show fittings// button.
+The //Check// button performs a manual check of the validity of the screw geometry. The screw geometry is also checked automatically each time a change is made.
+At the bottom of the window, the current screw configuration can be imported from a file, saved, transferred from another process or reset. If //Embedded// appears at the bottom of the display field, this means that the current screw configuration is saved in the associated process file.
 ===Further topics===