Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:eingabe_der_schneckendaten:kompressions-_und_dekompressionszone [2024/10/25 15:48] – neelest
+++ en:eingabe_der_schneckendaten:kompressions-_und_dekompressionszone [2025/05/05 10:52] (aktuell) – cschall
@@ Zeile 1: / Zeile 1: @@
 ======Compression and Decompression section ======
-In addition to the information needed for the sections with a constant channel depth a
+In addition to the information required for constant depth zones, a second depth must be specified for compression and decompression zones.
-second channel depth must be entered with the compression and decompression
+For a correct overview of the zone types of a screw, a compression zone MUST have a [[en:berechnungen:kompressionsverhaeltnisse|compression ratio CR]] of greater than 1 and a decompression zone a compression ratio CR of less than 1. The compression section/decompression section type can be easily changed in the input dialogue at the touch of a button.
-section. If for the channel depth h_1 a greater value is entered into the input mask of the
-compression section than for the beginning channel width h_0 REX/PSI will change
-this section automatically into a decompression section. This is also valid vice versa.
-Another special feature is that a constant pitch does not have to be used, but can be specified separately for the start and end of the zone. A continuous change in the aisle gradient is calculated over the entire length of the zone.
+Another special feature is that a constant pitch does not have to be used, but can be specified separately for the start and end of the section. A continuous change of the pitch is assumed over the entire length of the section.
 {{ :eingabe_der_schneckendaten:rex171_dek_komp_en_001.png?nolink |}}
@@ Zeile 23: / Zeile 20: @@
   * [[en:eingabe_der_schneckendaten:stegwechselzone|]]
   * [[en:eingabe_der_schneckendaten:wave-zone|]]
-  * [[en:eingabe_der_schneckendaten:pin-zone|]]
 ==Input of shearing and mixing parts==