≪ View Page

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen RevisionVorhergehende Überarbeitung
en:eingabe_der_schneckendaten:kompressions-_und_dekompressionszone [2025/05/05 10:51] – cschallen:eingabe_der_schneckendaten:kompressions-_und_dekompressionszone [2025/05/05 10:52] (aktuell) – cschall
Zeile 4: Zeile 4:
 For a correct overview of the zone types of a screw, a compression zone MUST have a [[en:berechnungen:kompressionsverhaeltnisse|compression ratio CR]] of greater than 1 and a decompression zone a compression ratio CR of less than 1. The compression section/decompression section type can be easily changed in the input dialogue at the touch of a button. For a correct overview of the zone types of a screw, a compression zone MUST have a [[en:berechnungen:kompressionsverhaeltnisse|compression ratio CR]] of greater than 1 and a decompression zone a compression ratio CR of less than 1. The compression section/decompression section type can be easily changed in the input dialogue at the touch of a button.
  
-Another special feature is that a constant pitch does not have to be used, but can be specified separately for the start and end of the zone. A continuous change in the aisle gradient is calculated over the entire length of the zone. +Another special feature is that a constant pitch does not have to be used, but can be specified separately for the start and end of the section. A continuous change of the pitch is assumed over the entire length of the section. 
  
 {{ :eingabe_der_schneckendaten:rex171_dek_komp_en_001.png?nolink |}} {{ :eingabe_der_schneckendaten:rex171_dek_komp_en_001.png?nolink |}}