Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:eingabe_der_schneckendaten:mailleferzone [2024/10/17 16:21] – [Maillefer section] neelest
+++ en:eingabe_der_schneckendaten:mailleferzone [2025/05/05 15:20] (aktuell) – [Maillefer section] cschall
@@ Zeile 9: / Zeile 9: @@
 {{ :eingabe_der_schneckendaten:abb_maillefer_en.svg?700 |}}
-All geometry parameters affect the width of the solid channel at the start respectively
+All geometry size specifications affect the solid channel width at the beginning and end and the melt channel width at the end of the maillefer zone, which cannot be edited. The melt channel width at the start of the maillefer zone b_s_00 must be entered.
-the end and the width of the melt channel at the end of the Maillefer section. These
-cannot be edited. The width of the melt channel at the start of the Maillefer section
-b_s_MO has to be entered.
-What's more, at 1 is shown the design of the screw channel. The zones are
-separated by the vertical black lines. Illustrated from left to right one can see the
-previous section of the barrier section. Following the Maillefer section. The main flight
-is shown blue, the barrier flight is red. Finally, the illustration presents the following
-zone of the barrier section.
-The current section is bordered in black. In this case it is the inflow section. By sliding
-the cursor over the illustration, the type of each section appears in a bubblehelp.
 {{ :eingabe_der_schneckendaten:rex171_zonen_en_001.png?nolink |}}
@@ Zeile 36: / Zeile 24: @@
   * [[en:eingabe_der_schneckendaten:stegwechselzone|]]
   * [[en:eingabe_der_schneckendaten:wave-zone|]]
-  * [[en:eingabe_der_schneckendaten:pin-zone|]]
 ==Input of shearing and mixing parts==