≪ View Page

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen RevisionVorhergehende Überarbeitung
Nächste Überarbeitung		Vorhergehende Überarbeitung
en:eingabe_eines_werkzeugs:eingabe_einer_werkzeugkennlinie [2025/05/14 09:57] – [Input of a die characteristic (REX)] cschallen:eingabe_eines_werkzeugs:eingabe_einer_werkzeugkennlinie [2025/05/14 10:02] (aktuell) – [Calculation of pressure and mass throughput] cschall
Zeile 8: Zeile 8:
 In order to carry out the simulation correctly, the data of a real operating point must be entered into the mould configuration. This operating point forms the basis for the calculations and is characterised by the following parameters: In order to carry out the simulation correctly, the data of a real operating point must be entered into the mould configuration. This operating point forms the basis for the calculations and is characterised by the following parameters:
  
-  *     **Mass throughput**: The actual material flow that is conveyed through the mould. +  *     **Mass throughput**: The actual material flow that is conveyed through the die. 
-  *     **Tool back pressure**: The pressure that is applied to the tool and influences the material flow.+  *     **Die back pressure**: The pressure that is applied to the tool and influences the material flow.
   *     **Measured melt temperature**: The temperature of the material recorded at this operating point.   *     **Measured melt temperature**: The temperature of the material recorded at this operating point.
  
 As an operating point can only ever be run with a specific material, a material must be defined in the process before the simulation to ensure that the simulation is carried out consistently with the real conditions. As an operating point can only ever be run with a specific material, a material must be defined in the process before the simulation to ensure that the simulation is carried out consistently with the real conditions.
  
-====Determination of the conductance====+====Determination of the die coefficient====
  
-After entering the operating data mentioned above, the conductance of the mould is determined. The conductance is a characteristic value for the respective tool and describes the pressure-throughput behaviour as a function of the process conditions.+After entering the operating data mentioned above, the die coefficient of the tool is determined. The die coefficient is a characteristic value for the respective tool and describes the pressure-throughput behaviour as a function of the process conditions.
  
 ====Calculation of pressure and mass throughput==== ====Calculation of pressure and mass throughput====
  
-By combining the process parameters of the screw and the conductance of the mould, REX can calculate the pressure at the tip of the screw and the conveyable mass throughput.+By combining the process parameters of the screw and the die coefficient of the tool, REX can calculate the pressure at the tip of the screw and the conveyable mass throughput.
  
 ===Further topics=== ===Further topics===