Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:eingabe_eines_werkzeugs:eingabe_einer_werkzeugkennlinie [2025/05/14 09:58] – [Definition of the operating point] cschall
+++ en:eingabe_eines_werkzeugs:eingabe_einer_werkzeugkennlinie [2025/05/14 10:02] (aktuell) – [Calculation of pressure and mass throughput] cschall
@@ Zeile 14: / Zeile 14: @@
 As an operating point can only ever be run with a specific material, a material must be defined in the process before the simulation to ensure that the simulation is carried out consistently with the real conditions.
-====Determination of the conductance====
+====Determination of the die coefficient====
-After entering the operating data mentioned above, the conductance of the mould is determined. The conductance is a characteristic value for the respective tool and describes the pressure-throughput behaviour as a function of the process conditions.
+After entering the operating data mentioned above, the die coefficient of the tool is determined. The die coefficient is a characteristic value for the respective tool and describes the pressure-throughput behaviour as a function of the process conditions.
 ====Calculation of pressure and mass throughput====
-By combining the process parameters of the screw and the conductance of the mould, REX can calculate the pressure at the tip of the screw and the conveyable mass throughput.
+By combining the process parameters of the screw and the die coefficient of the tool, REX can calculate the pressure at the tip of the screw and the conveyable mass throughput.
 ===Further topics===