Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Nächste Überarbeitung | Vorhergehende Überarbeitung | ||
| en:grafische_darstellung_der_ergebnisse:faserlaengenabbau [2025/06/06 15:02] – angelegt admin | en:grafische_darstellung_der_ergebnisse:faserlaengenabbau [2025/09/05 10:27] (aktuell) – [Analysis of the fibre lenght reduction] neelest | ||
|---|---|---|---|
| Zeile 1: | Zeile 1: | ||
| ======Fiber length reduction====== | ======Fiber length reduction====== | ||
| + | |||
| + | -> [[..: | ||
| + | |||
| + | ===== Representation of the fibre length reduction ===== | ||
| + | |||
| + | {{ : | ||
| + | |||
| + | ===== Interpretation of the curves ===== | ||
| + | |||
| + | * **Red curve**: The red curve represents the average fibre length over the screw position. The starting value and the fibre properties are specified in the [[..: | ||
| + | |||
| + | ===== Analysis of the fibre lenght reduction ===== | ||
| + | |||
| + | In principle, a long fibre length at the end of the screw and therefore also in the product is desirable. A possible downstream fibre shortening (e.g. when injecting an injection moulding machine) is not considered. In the process, it is possible to see which screw zone leads to which shortening of the fibre length. This information can be used for a fibre-friendly screw design. | ||
| + | |||
| + | ===Further topics=== | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[faserlaengenabbau|]] | ||
| + | * [[faserlaengenverteilung|]] | ||
| + | * [[spannungsanalyse|]] | ||
| + | * [[kennlinienfeld|]] | ||
| + | * [[entgasung|]] | ||
| + | * [[zykluszeit|]] | ||
| + | * [[en: | ||
| + | * [[en: | ||