Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende Überarbeitung | ||
| en:grafische_darstellung_der_ergebnisse:faserlaengenabbau [2025/06/06 18:50] – neelest | en:grafische_darstellung_der_ergebnisse:faserlaengenabbau [2025/09/05 10:27] (aktuell) – [Analysis of the fibre lenght reduction] neelest | ||
|---|---|---|---|
| Zeile 15: | Zeile 15: | ||
| In principle, a long fibre length at the end of the screw and therefore also in the product is desirable. A possible downstream fibre shortening (e.g. when injecting an injection moulding machine) is not considered. In the process, it is possible to see which screw zone leads to which shortening of the fibre length. This information can be used for a fibre-friendly screw design. | In principle, a long fibre length at the end of the screw and therefore also in the product is desirable. A possible downstream fibre shortening (e.g. when injecting an injection moulding machine) is not considered. In the process, it is possible to see which screw zone leads to which shortening of the fibre length. This information can be used for a fibre-friendly screw design. | ||
| + | ===Further topics=== | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[en: | ||
| + | * [[faserlaengenabbau|]] | ||
| + | * [[faserlaengenverteilung|]] | ||
| + | * [[spannungsanalyse|]] | ||
| + | * [[kennlinienfeld|]] | ||
| + | * [[entgasung|]] | ||
| + | * [[zykluszeit|]] | ||
| + | * [[en: | ||
| + | * [[en: | ||