Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:grafische_darstellung_der_ergebnisse:zykluszeit [2025/09/05 10:28] – [Cycle Time Analysis] neelest
+++ en:grafische_darstellung_der_ergebnisse:zykluszeit [2026/09/09 16:13] (aktuell) – [Interpretation of Cycle Time] cschall
@@ Zeile 9: / Zeile 9: @@
 The cycle time can be displayed via “//Graphics > Cycle Time//”.
-{{ :grafische_darstellung_der_ergebnisse:psi180_grafisch_en_001.png?nolink |}}
+{{ :grafische_darstellung_der_ergebnisse:psi190_grafisch_zykluszeit_en.png?nolink |}}
 ===== Interpretation of Cycle Time =====
-  * **Metering Time**: The metering time corresponds to the duration required by the plasticizing unit to provide the shot volume. It is either predefined or calculated depending on the [[..:berechnungen:zykluszeitberechnung|cycle time calculation]].
+  * **Plasticising Time**: The plasticising time corresponds to the duration required by the plasticizing unit to provide the shot volume. It is either predefined or calculated depending on the [[..:berechnungen:zykluszeitberechnung|cycle time calculation]].
-  * **Injection Time**: The injection time corresponds to the duration required for the injection process (excluding the holding pressure phase). This is a [[..:eingabe_der_verfahrensparameter:eingabe_der_verfahrensparameter|mandatory user input]].
+  * **Injection Time**: The injection time corresponds to the duration required for the injection process (excluding the holding pressure phase). This is a [[..:eingabe_der_verfahrensparameter:eingabe_der_verfahrensparameter#necessary_inputs|mandatory user input]].
-  * **Other**: This category covers all subsequent process steps such as holding pressure time, mold movement time, injection unit movement time, and possible residual cooling time.
+  * **Holding-pressure time**: The holding-pressure time is an [[..:eingabe_der_verfahrensparameter:eingabe_der_verfahrensparameter#inputs_for_calculating_the_closing_time_of_the_non-return_valve|optional input]]
-  * **Idle and Cycle Time**: The cycle time describes the time needed to complete one full injection molding cycle. The cycle time minus the metering time corresponds to the idle time, during which the injection screw is not moving.
+  * **Dry cycle time**: This category covers all subsequent process steps such as mold movement time, injection unit movement time, and possible residual cooling time.
+  * **Downtime and Cycle Time**: The cycle time describes the time needed to complete one full injection molding cycle. The cycle time minus the plasticising time corresponds to the downtime, during which the screw is not moving.
 ===== Cycle Time Analysis =====