≪ View Page

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen RevisionVorhergehende Überarbeitung
Nächste Überarbeitung		Vorhergehende Überarbeitung
en:grafische_darstellung_der_ergebnisse:zykluszeit [2026/09/09 16:12] – cschallen:grafische_darstellung_der_ergebnisse:zykluszeit [2026/09/09 16:13] (aktuell) – [Interpretation of Cycle Time] cschall
Zeile 15: Zeile 15:
   * **Plasticising Time**: The plasticising time corresponds to the duration required by the plasticizing unit to provide the shot volume. It is either predefined or calculated depending on the [[..:berechnungen:zykluszeitberechnung|cycle time calculation]].   * **Plasticising Time**: The plasticising time corresponds to the duration required by the plasticizing unit to provide the shot volume. It is either predefined or calculated depending on the [[..:berechnungen:zykluszeitberechnung|cycle time calculation]].
   * **Injection Time**: The injection time corresponds to the duration required for the injection process (excluding the holding pressure phase). This is a [[..:eingabe_der_verfahrensparameter:eingabe_der_verfahrensparameter#necessary_inputs|mandatory user input]].   * **Injection Time**: The injection time corresponds to the duration required for the injection process (excluding the holding pressure phase). This is a [[..:eingabe_der_verfahrensparameter:eingabe_der_verfahrensparameter#necessary_inputs|mandatory user input]].
-  * **Holding-pressure time**: The holding-pressure time is an [[..:eingabe_der_verfahrensparameter:eingabe_der_verfahrensparameter#eingaben_zur_berechnung_der_schliesszeit_der_rueckstromsperre#inputs_for_calculating_the_closing_time_of_the_non-return_valve|optional input]]+  * **Holding-pressure time**: The holding-pressure time is an [[..:eingabe_der_verfahrensparameter:eingabe_der_verfahrensparameter#inputs_for_calculating_the_closing_time_of_the_non-return_valve|optional input]]
   * **Dry cycle time**: This category covers all subsequent process steps such as mold movement time, injection unit movement time, and possible residual cooling time.   * **Dry cycle time**: This category covers all subsequent process steps such as mold movement time, injection unit movement time, and possible residual cooling time.
-  * **Idle and Cycle Time**: The cycle time describes the time needed to complete one full injection molding cycle. The cycle time minus the metering time corresponds to the idle time, during which the injection screw is not moving.+  * **Downtime and Cycle Time**: The cycle time describes the time needed to complete one full injection molding cycle. The cycle time minus the plasticising time corresponds to the downtime, during which the screw is not moving.
  
 ===== Cycle Time Analysis ===== ===== Cycle Time Analysis =====