≪ View Page

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen RevisionVorhergehende Überarbeitung
Nächste Überarbeitung		Vorhergehende Überarbeitung
en:rex3d:rex3dpostprocessing [2026/08/31 11:21] – [PDF Report] adminen:rex3d:rex3dpostprocessing [2026/09/01 12:24] (aktuell) – admin
Zeile 7: Zeile 7:
 ===== Post-Processing (OpenFOAM) ===== ===== Post-Processing (OpenFOAM) =====
  
-{{ :rex3d:openfoamreport:rex19_openfoam_postpro_de.png?nolink |}}+{{ :rex3d:openfoamreport:rex19_openfoam_postpro_en.png?nolink |}}
  
 ==== Post-Processing Settings ==== ==== Post-Processing Settings ====
Zeile 87: Zeile 87:
 The thermodynamic data and density are then displayed: The thermodynamic data and density are then displayed:
  
-  * [[materialdaten:thermodynamische_daten|Thermal conductivity]] at 0°C and its slope per °C +  * [[en:materialdaten:thermodynamische_daten|Thermal conductivity]] at 0°C and its slope per °C 
-  * [[materialdaten:thermodynamische_daten|Heat capacity]] at 0°C and its slope per °C +  * [[en:materialdaten:thermodynamische_daten|Heat capacity]] at 0°C and its slope per °C 
-  * [[materialdaten:dichtedaten_bzw._spezifisches_volumen|Melt density]] at 0°C and the reduction in density per °C+  * [[en:materialdaten:dichtedaten_bzw._spezifisches_volumen|Melt density]] at 0°C and the reduction in density per °C
  
-Finally, the [[materialdaten:rheologische_materialdaten|Rheological Data]] are listed. This starts with the temperature shift, followed by the viscosity. Different parameters are listed depending on the selected model.+Finally, the [[en:materialdaten:rheologische_materialdaten|Rheological Data]] are listed. This starts with the temperature shift, followed by the viscosity. Different parameters are listed depending on the selected model.
  
 To visualize the viscosity, a diagram with flow curves for three different temperatures is shown. These are the inlet temperature (see Process Data), as well as temperatures 20 °C below and above the inlet temperature. To visualize the viscosity, a diagram with flow curves for three different temperatures is shown. These are the inlet temperature (see Process Data), as well as temperatures 20 °C below and above the inlet temperature.
Zeile 314: Zeile 314:
  
 ===Further Topics=== ===Further Topics===
- +  * [[en:rex3d:rex3dpreprocessing|]] 
-  * [[rex3d:rex3dpreprocessing|]] +  * [[en:Rex3d:Rex3dPostProcessing]] 
-  * [[rex3d:rex3dpostprocessing|]] +  
-  * [[rex3d:rex3dkonfiguration|]] +  * [[en:Rex3d:Rex3dKonfiguration]] 
 +  * [[en:Rex3d:openfoamremote]]