Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:rex3d:rex3dpostprocessing [2026/08/31 11:24] – [Post-Processing (OpenFOAM)] admin
+++ en:rex3d:rex3dpostprocessing [2026/09/01 12:24] (aktuell) – admin
@@ Zeile 87: / Zeile 87: @@
 The thermodynamic data and density are then displayed:
-  * [[materialdaten:thermodynamische_daten|Thermal conductivity]] at 0°C and its slope per °C
+  * [[en:materialdaten:thermodynamische_daten|Thermal conductivity]] at 0°C and its slope per °C
-  * [[materialdaten:thermodynamische_daten|Heat capacity]] at 0°C and its slope per °C
+  * [[en:materialdaten:thermodynamische_daten|Heat capacity]] at 0°C and its slope per °C
-  * [[materialdaten:dichtedaten_bzw._spezifisches_volumen|Melt density]] at 0°C and the reduction in density per °C
+  * [[en:materialdaten:dichtedaten_bzw._spezifisches_volumen|Melt density]] at 0°C and the reduction in density per °C
-Finally, the [[materialdaten:rheologische_materialdaten|Rheological Data]] are listed. This starts with the temperature shift, followed by the viscosity. Different parameters are listed depending on the selected model.
+Finally, the [[en:materialdaten:rheologische_materialdaten|Rheological Data]] are listed. This starts with the temperature shift, followed by the viscosity. Different parameters are listed depending on the selected model.
 To visualize the viscosity, a diagram with flow curves for three different temperatures is shown. These are the inlet temperature (see Process Data), as well as temperatures 20 °C below and above the inlet temperature.
@@ Zeile 314: / Zeile 314: @@
 ===Further Topics===
+  * [[en:rex3d:rex3dpreprocessing|]]
-  * [[rex3d:rex3dpreprocessing|]]
+  * [[en:Rex3d:Rex3dPostProcessing]]
-  * [[rex3d:rex3dpostprocessing|]]
-  * [[rex3d:rex3dkonfiguration|]]
+  * [[en:Rex3d:Rex3dKonfiguration]]
+  * [[en:Rex3d:openfoamremote]]