Cross-hole mixing section

In the cross-hole mixing section, the distances between the mixing rings are referred to as gaps. The channel depths also refer to these gaps. The difference between the number of rings and the number of gaps must not exceed 1. The width of the gaps is calculated from the other sizes and can therefore not be edited.

• Define screw data
• Define internally tempered screws
• General notes on defining the screw geometry
• Feed, Metering and Venting section
• Compression and Decompression section
• Barrier section
• Maillefer section
• Flight switch section
• Wave-Zone

• Maddok shearing section
• Spiral shearing section
• Toothed disc mixing section
• Faceted mixing section
• Cross-hole mixing section
• Cylindrical and conical shearing section
• Troester shearing section
• Cavity mixing section

• NRV - Cylindrical and conical NRV element
• NRV - Ring segment
• NRV - Pipe segment
• NRV - Annular non-return valve