Dies ist eine alte Version des Dokuments!
Feed, Metering and Venting section
The input mask for zones with constant channel depth are identical for the feed, metering, and degassing zones. The distinction serves to allow precise specification of the screw zones and to set the screw diameter only in the feed zone. The geometric parameters to be entered form the basis for the calculation algorithms implemented in the program and must be fully defined.
The following illustration shows the geometry of a single flight screw section.
| Input identifier | Description |
|---|---|
| L or L/D | Length of the zone |
| δ (delta) | Screw clearance |
| i | No. of flights |
| r_1 | Radius active flight |
| r_2 | Radius non active flight |
| γ (gamma) | Flight angle |
| e | Flight width |
| t or t/D | Pitch |
| h_E, h_M, h_0 | Channel depth (E: Intake, Metering, 0: Degassing) |
The corresponding input screen (feed zone) with the required sizes is shown below:
Once all input variables have been defined, the following variables are calculated automatically:
| Calculated identifier | Description |
|---|---|
| b | Channel width |
| A_q | Channel cross section |
| V_K | Channel volume |
The dialogues of the metering and degassing zones differ only in the illustration and the designation of the aisle depth h_0 (degassing zone), h_M (metering zone).
